Special thanks to Keith Doneski for suggesting this new item.

The Banjo Table mounts into your lathe's banjo and gives you a stable working platform. It is available for both 1" and 5/8" post lathes.

Who needs this table?

Segmented turners wishing to touch up the segments with a lathe-mounted sanding disk with or without using a miter gauge (not included)
Basketweave illusion artists can draw straight even lines on the blank.
Ideal for fluting with a Router and indexing wheel system
Anyone needing a flat stable platform mounted on the lathe to allow controlled access to the workpiece such as carving, drilling equidistant holes, etc.

The standard table size is 7"x7"x5/8" thick and is made from very durable HDPE. All 1" post models use a heavy-duty 3.5" steel faceplate for the interface and mount directly into the banjo with the supplied 1" post. The 5/8" post models use a 2.75" diameter steel floor flange and mount directly into your lathe's banjo also.

The standard table is 7"x7"x5/8" thick. We offer larger sizes of the same thickness at an additional charge.

Standard Size Table 7x7, or upgrade:

Long Size Table 7x14, Add $10.00

Large Table 10x10, Add $17.50

Extra Large Table 14x14 (must have 1" post), Add $25.00

Information message.

If you need a custom size or shape not listed, call us at (770) 962-3821 Eastern and let's discuss your needs. Below a customer asked for a double and here it is a two miter slot table to run your sled through. This option is only available for the 1inch post size. Any question is never too much to ask!

Banjo Table