Amazing Steady Rest Type 2 - 12 inch/10 inch

I have completely redesigned the Steady Rest with features not found at this price range.

You need a steady rest if you turn long thin spindles or hollow taller vessels. You can't use the tailstock during hollowing and the piece is prone to being pulled off-center if the chuck slips even a little bit. Steady rests prevent that.

Using a steady rest eliminated most all vibration and chatter on thin spindles. When the wall on a bowl gets thin it tends to vibrate and rough cuts are the result. A steady can eliminate that vibration and give a much better finish cut. With taller vessels further away from the chuck, the more leverage works against you and the more likely you are to pull the vessel off-center. It doesn't take much to make a huge difference in concentricity.

• I have re-designed these steady rests for strength and accessibility.
• They open completely by removing one bolt and loosening another.
• All adjustments are toolless.
• The bases are all 80/20 extruded aluminum, are 1 inch thick and 3 inches wide with multiple channels to mount accessories.
• The wheels are all equipped with dual ABEC7 bearings.
• If you turn a lot replacement wheels are widely available for $5 to $9 each including new bearings.
• 3 Sizes are available to fit most size wood lathes up to 20" - (10/12, 14/16, 18,20)
• colors may vary

• New for 2024 Accessory Now included at no extra cost.

  Braces for 16” steadies and larger. Adds extra lateral rigidity. Not for 10” through 14” models.